Back to Door Canopies

Raised lead-look canopy with rolled lead detailing fitted to the traditional moulded fascia with smooth undertray. Excellent for porch or bay conversions. Normally supplied with GRP brackets (BRG 5)
Available in any size up to 3000mm maximum length.

Min Width : 1500mm - Max Width : 3000mm

All canopies come with a fitting kit and instructions.

 

• Mark out and pre-drill 6mm holes at approx 300mm centres along the canopy flanges (some canopies may have a tray and lid assembly).
  
   
• Offer canopy up to the wall and centralise it above the door opening. Mark off the position on the wall for the bracket assembly (if brackets are to be fitted). Make sure you markings are straight and level.
  
   
• Offer the bracket up to the wall at each side of the door opening. Drill and plug the wall using a 7mm masonry drill bit. Screw the bracket to the wall using 3" screws and plugs supplied.

  
   

• Lift the canopy onto the brackets and centralise over the door opening. Drill and plug the wall as before, this time using 2"screws and plugs supplied.
  
   
• Cover all visible screw heads with the appropriate coloured screw caps.
  
   
• Clean canopy using soap and water or a non-abrasive cleaner.
  
   
• Seal canopy to the wall using and appropriate colour sealer. (Sealer is not supplied).
  
   
• Your over door canopy is maintenance-free, however we recommend regular cleaning with soap and water to maintain it's good looks for many years to come.

Care should be taken not to stand on the canopy as this may cause cracking or damage to the surface finish. Always check your canopy for damage before you sign for it.